Windows dns forward lookup zone not updating

Configuring Reverse Lookup Zones Now, we need to create a matching reverse lookup zone. On the Reverse Lookup Zone Name page, make sure IPv4 is selected, and then click Next.7. On the Completing The New Zone Wizard page, click Finish. Right-click the Network connection and choose Properties.5.

This will handle reverse resolution for our subnet. On the Reverse Lookup Zone Name page, in the Network ID field, type the start of the subnet range of your network (in this case, 192.168.1.x), and then click Next.8. Now we need to enable IPv6 so we can offer domain name resolution for clients who may use IPv6 as opposed to IPv4. Double-click Internet Protocol Version 6 (TCP/IPv6).6. Click the radio button for Use The Following IPv6 Address.

windows dns forward lookup zone not updating-36windows dns forward lookup zone not updating-49windows dns forward lookup zone not updating-54

Likewise, you can right-click the zone and select Properties to modify the properties of the zone.

We’re also going to need it if we want to enable IPv6 DHCP addressing. If you are not familiar with IP addressing, you can use 2001:0dbcd:1a0f:857b:455b:b4ec:7403.7. Your preferred DNS server would be the same as that mentioned earlier (your IPv6 address).9.

First, we need to set an IPv6 address for our server. Close the Network Connections window and re-open the DNS administrator console.10.

The reason the IP addresses are inverted is that IP addresses, when read from left to right, get more specific; the IP address starts with the more general information first.

FQDNs, in contrast, get more general when read from left to right; the FQDN starts with a specific host name.

Leave a Reply